SUPERNOVA 316 Slickline

UNS S31600 WN 1.4401 PRE: 23.5 – 27​

With its combination of high break loads and good pitting and crevice corrosion resistance, Supernova 316® is a cost-effective solution for less corrosive oil and gas wells with zero H2S.

Manufactured in Switzerland and certified to 9001: 2008 all Supernova Slicklines are fully traceable, 100% Weld Free, 100% Eddy Current Tested and Wrap Tested.

All are produced with a consistent, tightly controlled surface finish, wire helix and wire cast for optimal spooling and in-service performance.



Key Characteristics
 

• Good general corrosion resistance in wells with medium concentrations of CO2 (up to 30%) and low chlorides (up to 2.5%) with both moderate Bottom Hole Temperatures and Pressures and no H2S

 

• Excellent resistance to general corrosion

 

• High break loads due to high tensile strength

 

• May be used in temperatures up to 150°C in less corrosive environments

 

• Subject to pitting and crevice corrosion in warm chloride environments and to stress corrosion cracking above 60°C

 

• An economical option where carbon (plow) slicklines may fail due to corrosion

 

• Not recommended for wells containing H2S

Key Data

Standard Diameter (Inches)	Min Breaking Load (lbf)	Min Tensile (N/mm2)   (Ksi)		Nominal Weight (lbs/ 1000ft)	Minimum Slickline Stretch (Inch/100ft/ 100lb)	Minimum Sheave Diameter (Inches)
0.092	1420	1460	214	22.64	0.83	11
0.108	1940	1440	212	31.20	0.60	13
0.125	2530	1420	206	41.80	0.45	15
0.140	3130	1410	203	53.00	0.36	17
0.160	4050	1380	202	69.00	0.22	20

(1) Tolerance +/-0.001" – other diameters are available on request. (2) Weight of tool string plus weight of wire of the drum.



Chemical Composition
 

Element		C	Si	Mn	P	S	Cr	Mo	Cu	Ni	N
Weight %	Min	-	-	-	-	-	16.50	2.00	-	10.00	0.03
	Max	0.08	1.00	2.00	0.045	0.030	18.00	2.60	-	13.80	0.06

 


Other Slickline Grades

 






To request for a detailed specification of these wireline (slicklines), please